FreeTrack Forum - Unwanted Translation during Rotation

Home

Welcome, you're not connected. ( Log in - Register )

FreeTrack Forum > FreeTrack : English Forum > Support : FreeTrack Software > Unwanted Translation during Rotation

RSS > Unwanted Translation during Rotation

Oznerol	#1 29/04/2011 - 13h39 Top
Class : Apprenti Posts : 6 Registered on : 29/04/2011 Off line	Hi community, two weeks ago i found freetrack. And since one and a half week i am trying to get my 3 points cap perfectly working. my problem is actually translation during rotation. If I move my head to left or right the 3D-Preview shows that my head has moved far backwards. How do i get rid of that? Sorry for bad English, i live in Germany.
albx	#2 29/04/2011 - 16h57 Top
Class : Habitué Posts : 70 Registered on : 26/08/2010 Off line	measure very precise your model and put the dimensions in the software
Oznerol	#3 29/04/2011 - 19h36 Top
Class : Apprenti Posts : 6 Registered on : 29/04/2011 Off line	Thanks for your reply man! I measured my model again and very precise. The effect has become smaller. But the effect is still there. Edited by Oznerol on 29/04/2011 at 19h42. Sorry for bad English, i live in Germany.
Vink	#4 29/04/2011 - 21h48 Top
Class : Apprenti Posts : 20 Registered on : 08/01/2011 Off line	On a Profile Tab look at the Map boxes in Settings frame. Check the settings there: Yaw shoud read Yaw Pitch should read Pitch Roll shoulb be Roll X -> X Y->Y Z->Z These settings define your translations
Oznerol	#5 29/04/2011 - 23h06 Top
Class : Apprenti Posts : 6 Registered on : 29/04/2011 Off line	All my settings are nominal. The Mapping-Settings included. I found a fault in my model which made also a bit of the effect: one of the lower leds were further away from the Reference point than the other. Just a few Mimmimeters, but after killing the mm's it works better. Now it is almost perfect. Using small deadzone the effect is eliminated. Thanks for the replys! Sorry for bad English, i live in Germany.
Zaphod	#6 30/04/2011 - 10h14 Top
Class : Apprenti Posts : 48 Registered on : 29/04/2009 Off line	If you play with the model position sliders for a while you can reduce it quite a bit.
Oznerol	#7 30/04/2011 - 13h24 Top
Class : Apprenti Posts : 6 Registered on : 29/04/2011 Off line	I was playing with them very long. I was able to reduce it quite a bit as you said, but it was still there. My problem was my unprecise model. `If you see the front of my model, it saw a bit like that. The one lower led wasn't as far away from the upper as the other. The result is unwanted Z axis translation during rotation to left and right. If i move my head to the left, the lower leds are very close on the screen. The result is that the skull of the Preview goes backwards. By looking th the right, the skull comes more in front. 0 \| +---+---+ \| \| \| 0 0` Sorry for bad English, i live in Germany.

FreeTrack Forum > FreeTrack : English Forum > Support : FreeTrack Software > Unwanted Translation during Rotation

> Stats

1 user(s) connected during the last 10 minutes (0 member(s) and 1 guest(s)).