FreeTrack Forum

What is wrong here, I can not adjust the dots on my screen, They are still white with a lot of crosses in it.
point diameter 2/26 min/max pixels, adjustments here no effect only to the amount of crosses.
The dots on the lower screen side are red and sometimes flashing to green

Help, I'm using the Osram IR/ MS VX1000  

HELLO, IS THERE ANYBODY WHO CAN HELP.

If the dots at the bottom are flickering green you're probably very close to a good setup. I would keep trying with adjusting the slider settings of the camera control. These are the settings that work best for me:

[advanced]
- disable automatic gain control!
- keep exposure as low as possible to get the highest framerate
- keep gain to zero if possible
- anti flicker: as appropriate for your system
- image enhancement - all disabled

[device settings]
- set brightness to highest possible level that still only produces 3 dots
- set contrast to highest possible value, lower if multiple crosses appear
- saturation to minimum value
- sharpness minimum value, to avoid multiple crosses per led
- white balance/backlight comp to zero

Make sure that your leds get enough voltage, and you did not mention if you had made the IR mod on your camera.

Hope you'll get it to work.

  Thanks I give up, still the same, I think I'm going for the Wii try.