FreeTrack Forum

Just today

1 'Smart' Bike Light with On/Off/Blink switch, using 2xAAA batteries (3.50eu)
remove the LEDs from the print (hold solderingiron against 2-pins-at-once on the back)
make sure connetions do Not short-connect by solder spillage (Volt-meter), or clean up (I had to)
sand down the LEDs as required for wide angle emitting
3 holes in red cover for T-frame
T-frame (220V installation wire), 1 piece X through-and-throught,
1 piece Y form top down, soldered at the (stripped) T
3 xtra holes in red cover for LED wires
ripped wire from an old IDE-cable (thin, not copper though)
solder LEDs to wires and back onto print (keep an eye on +)
attach LEDs to T-frame with peaces of garbage bag fastner
some bending of the T-frame
black sticker on red cover because I found light reflections

remove Light from old Headband Light
screw Bike Light mount to Headband base

et voila

works
AND uses the Switch from the original Bike Lamp (blinks also)







and
bought a MS VX-3000 for 32eu
and NO hardware Mods
works out-of-the-box with above

http://forum.free-track.net/index.php?showtopic=1130