FreeTrack Forum

Welcome, you're not connected. ( Log in - Register )

FreeTrack Forum > FreeTrack : English Forum > Support : Tracking System > How to increase the field of view?

RSS >  How to increase the field of view?
Flashsim #1 16/08/2007 - 09h48

Class : Apprenti
Posts : 1
Registered on : 16/08/2007

Off line

Hi to everybody and many thanks for your wonderful software.

I've played with Cam2Pan, Freelook and, now, FreeTrack that is working perfectly with IL2 in mouse emulation with a Philips TouchCam Pro II and a single led. It is very simple to configure with respect to the other two softwares.

The only item where Fleelook gives me a better response is the Fiel of View:
In Il2 I'm not able to see in the rear angles of the canopy (eg. no more than the wings). Maybe it is matter of setting properly FreeTrack.
I've tried to modify the FOV in IL2 , sensivity and response curbes in FreeTrack, but it seems to me that these parameters are mostly related with the response speed, while my task is to increase the maximum output rotation angles.

Is there anyone who can give me a suggestion about this question?

Thak you again for your work: so many simmers will enjoy it!

Flashsim
Kestrel #2 16/08/2007 - 10h33

Webmaster (admin)
Class : Webmaster (admin)
Posts : 780
Registered on : 13/07/2007

Off line

Make sure the right-most point of each response curve is as far right as possible, this controls the maximum limit for each axis. Freetrack v2.0 has a maximum of +/- 160 degrees, the next version will be +/- 180 degrees, but you should still have a good rear view at 160 degrees.
C6_LeBorgne #3 16/08/2007 - 10h41

Class : Beta Tester
Posts : 224
Registered on : 09/08/2007

Off line

With il2 you may have better feeling in Track-ir mode .

check this
il2 with Freetrack
Edited by C6_LeBorgne on 16/08/2007 at 10h42.
Posted Image
C2D 6420 , 2Go DDR II , 570 GTX , Wiimote , A-quip mini BT Dongle , Thrustmaster Warthog , Pro Gamer Command Unit et PCDASH2
spacefrog #4 22/08/2007 - 21h22

Class : Apprenti
Posts : 12
Registered on : 22/08/2007

Off line

I got the very same problem, I think it´s caused from the LED, not from the camera. When the LED is at angle almost disappears from screen. I think I need wide angle LEDs or an IR lamp and reflectors on my head. I will try the first option next week and if not ok I´ll try the second one.
C6_LeBorgne #5 22/08/2007 - 21h27

Class : Beta Tester
Posts : 224
Registered on : 09/08/2007

Off line

Il2 have full Track-Ir support and Freetrack works like TIR .

Check conf.ini



[rts]
.....
trackIRUse=1
.....

Then use Freetrack in TIr mode and enjoy !!!
Posted Image
C2D 6420 , 2Go DDR II , 570 GTX , Wiimote , A-quip mini BT Dongle , Thrustmaster Warthog , Pro Gamer Command Unit et PCDASH2
empf #6 23/08/2007 - 18h56

Class : Apprenti
Posts : 14
Registered on : 19/07/2007

Off line Mail

spacefrog @ 22/08/2007 - 23h22 a dit:

I got the very same problem, I think it´s caused from the LED, not from the camera. When the LED is at angle almost disappears from screen. I think I need wide angle LEDs or an IR lamp and reflectors on my head. I will try the first option next week and if not ok I´ll try the second one.



As a first aid you may try to sand the LEDs. In most cases it will give enough angle for the LEDs.

Also, you may try to increase the current in the LED circuit. I had problems at first when I used too much resistance with the LEDs (120ohm for 3 volts is not good, 82 ohms works fine). However, you must be careful not to roast the LEDs.
spacefrog #7 26/08/2007 - 08h30

Class : Apprenti
Posts : 12
Registered on : 22/08/2007

Off line

Well, that is what I done. I modded the cam as shown in another thread in this forum. I mean I took off the ir filter and put the negative in. My cam now pics up the ir LED PERFECTLY, absolutely PERFECTLY, I mean that. From every angle, no flickering, just one red point with a just one white cross. The problem though remains. I just can´t look beyond the end of the wings far right and far left in IL2:46.
    I´m using the rFactor profile (dunno why, I just couldn´t make a new one) and I got the mouse output set.  The game spesific Sensitivity is set to 60 for yaw and pitch, the average at 4. At rotation and translation curves I put the first dot at 10-10, the second at  20-160 and  the third at 50-160. At global axis adjustments I got the sensitivity at 88. It works just perfectly in Freetrack, I can look everywhere, every single angle. But as I use in game the field of view is becoming narrower, at far right/left I can see just my flaps. I also turned the TrackIR use at 1 in the conf.ini but I can´t say if anything´s changed, I saw no difference.
     So what can I do at this situation?? Are the game profiles of v.1 compatible with the v.2 ones?? Will it be a IL2 profile to download soon? Maybe someone got any tips or changes to do at my current profile? Any will be good, I thank you in advance......
C6_LeBorgne #8 26/08/2007 - 09h07

Class : Beta Tester
Posts : 224
Registered on : 09/08/2007

Off line

Il2 will work fine with Rfactor profile , but DO NOT USE mouse emulation ,Il2 works well with Track Ir Native mode !

1dot il2 profile
[Sensitivity]
Yaw=81
Pitch=84
Roll=71
X=100
Y=100
Z=100
[Deadzone]
Yaw=100
Pitch=100
Roll=100
X=100
Y=100
Z=100
Zooming=20
[Inverted]
Yaw=0
Pitch=0
Roll=0
X=0
Y=0
Z=0
[YawCfg]
X0=0
Y0=102
X1=2
Y1=58
X2=75
Y2=64
X3=320
Y3=2
[PitchCfg]
X0=0
Y0=100
X1=2
Y1=57
X2=73
Y2=60
X3=320
Y3=2
[RollCfg]
X0=0
Y0=102
X1=6
Y1=81
X2=56
Y2=57
X3=162
Y3=1
[XCfg]
X0=0
Y0=102
X1=2
Y1=48
X2=233
Y2=93
X3=320
Y3=2
[YCfg]
X0=0
Y0=102
X1=11
Y1=47
X2=219
Y2=101
X3=320
Y3=2
[ZCfg]
X0=0
Y0=102
X1=2
Y1=82
X2=156
Y2=44
X3=290
Y3=2
[Mouse]
Enabled=0
[Output]
Mouse=0
Joystick=0
TIR=1
[Defaults]
Average=1


With 3 or 4 dot you may modify Average settings ..
Edited by C6_LeBorgne on 26/08/2007 at 09h11.
Posted Image
C2D 6420 , 2Go DDR II , 570 GTX , Wiimote , A-quip mini BT Dongle , Thrustmaster Warthog , Pro Gamer Command Unit et PCDASH2
spacefrog #9 26/08/2007 - 17h42

Class : Apprenti
Posts : 12
Registered on : 22/08/2007

Off line

C6 I thank you from the bottom of my heart!!!! I think the problem was the mouse output. I turned the TIR output on instead and it works just wonderful, absolutely marvelous. You made an old man happy my friend!!!!:D  I have to say the support in this forum is more than outstanding and this software is just a wonder!!!! I will dive now at the secrets of WW2 fighter adventures, once again THANK YOU ALL!!!!!

 >  Fast reply

Message

FreeTrack Forum > FreeTrack : English Forum > Support : Tracking System > How to increase the field of view?

 >  Stats

1 user(s) connected during the last 10 minutes (0 member(s) and 1 guest(s)).