FreeTrack Forum

Welcome, you're not connected. ( Log in - Register )

RSS >  old new game
blackhatracing #1 15/04/2008 - 01h41

Class : Apprenti
Posts : 2
Registered on : 15/04/2008

Off line

can anyone help me get enemy engaged  (apache vs hokum) to run?For all you people out there who has never heard of it,its a fantastic helicopter sim game....
Deimos #2 15/04/2008 - 10h57

Class : Beta Tester
Posts : 120
Registered on : 07/11/2007

Off line

I think you mean Apache vs Havoc. Commanche vs Hokum is a second game in enemy engaged series.
After applying latest patches it should work fine. You can get them here:
http://www.razorworks.com/enemyengaged/
But i'd also recommend trying to get a hold of enemy engaged: commanche vs hokum. If the second game detects apache vs havoc installed, it will work as an addon instead of separate game - you'll have four flyable helicopters, campaigns from both parts, and 3d cockpits with trackir/FT support (in commanche and hokum).
There were also some unofficial patches including high resolution textures and 3d cockpits (and trackir/FT) support for apache and havoc as well, but i don't remember where i got them... Maybe someone else will have a hint.
Edited by Deimos on 15/04/2008 at 10h58.
blackhatracing #3 15/04/2008 - 22h46

Class : Apprenti
Posts : 2
Registered on : 15/04/2008

Off line

thanks for that info..i meant to say the game was commanche vs hokum......but again thanks for the info
Deimos #4 16/04/2008 - 10h51

Class : Beta Tester
Posts : 120
Registered on : 07/11/2007

Off line

The site where i got community patches and install info for them seems to be temporarily down, but i've found another page:
http://www.eechcentral.com/wiki/
In the download section, you'll find new texture packs, community patches and a 3d cockpit for apache - it's in community patches dir - a must-have if you have apache vs havoc as well - it's really hard to switch from a 3D commanche cockpit with 6DOF view control to 2D apache one without any POV control ;) .
Just make sure you patch the game to latest version before applying any community patches/mods
To make sure that new textures are displayed correctly, there'll be some eech.ini file editing required. You'll need to change these settings to 1 (they'll probably be set to 0 by default):

texture_colour=1
texture_filtering=1
mipmapping=1
dynamic_water=1


Also, since you're on this forum, you'll want to enable the trackir :) Again, change the line in eech.ini to 1:

TIR_6DOF setting to 1 within eech.ini

And in game press CTRL+DELETE and enjoy 6DOF view control
More info:
http://www.eechcentral.com/wiki/index.php?title=Troubleshooting
http://www.eechcentral.com/wiki/index.php?title=TrackIR
and:
http://www.simhq.com/forum/ubbthreads.php?ubb=postlist&Board=13

Good luck and don't get spotted by a ZSU ;)
Edited by Deimos on 16/04/2008 at 10h51.

 >  Fast reply

Message

 >  Stats

1 user(s) connected during the last 10 minutes (0 member(s) and 1 guest(s)).